What are the specific matters of maintenance and conservation of ultrafine grinding mills?
Do not look at ultra-fine mill is just made of a pile of ice cold iron products, but their service life is also limited, especially for the majority of users, in the daily use if you do not pay attention, it will shorten it Service life, advance to the end of life. Therefore, if you want to extend the life of ultrafine mill, the key lies in maintenance. The following Keli Rake summed up some specific matters for the maintenance of ultrafine grinding mills for the majority of users, and hopes to help the majority of users.
First, the operator is the most closely related and influential factor to the ultra-fine pulverizer. The standardized operation can guarantee the effective stability of the production and reduce the damage of the equipment. This requires the staff to undergo rigorous training. Can enter the work, as the saying goes Bole knows Maxima, skilled operators like Bole, can make superfine mill to play the best results.
Second, the external working environment of ultra-fine mills should be taken care to avoid open-air production. Exposure to sunlight and rain will cause varying degrees of damage to the mill. If water enters the body, the effect is even worse. The outer surface of the mill must be coated with anti-leakage. Rust grease, found that rust should be immediately dealt with and do a good job of anti-rust repair measures.
Third, ultra-fine mill parts should also be good maintenance, regular inspections and maintenance, one by one from the outside to the inside investigation, it is best to list the components of the mill components, beware of the phenomenon of omissions, found that the need to replace serious wear parts , Loose or missing bolts need to be filled and tightened.
Fourth, the lubrication of the transmission parts in the ultra-fine mill parts must be in place, the addition of lubricants is not easy to add too much or too little, the lubricant selection in the winter and summer seasons should be correct, and the cleaning work of this part must pay attention , Impurities will contaminate the lubricant and affect its lubricating effect. It is best to periodically clean up and add new lubricants according to the working strength.
Fifth, the working hours of the mill should be carefully planned to avoid overwork. The overwork operation not only has low production efficiency, but also has great damage to the machine. It is one of the killers that shortens the service life.
Sixth, the amount of material added in the production process and the humidity of the material should be controlled within an effective range. The material particles and the amount of the material added are large or small. All wear parts of the grinding wheel wear ring have certain wear and tear. Direct grinding will not only cause plugging, but also may rust internal parts.
The implementation of the seventh and the above links requires dedicated supervision and management departments to implement, formulate a reasonable management and operation system, maintenance and inspection methods, and implement it step by step according to the plan, and find that violations are promptly stopped to ensure that maintenance is done well.
Seven points of maintenance to do, ultra-fine mill failure frequency will be properly reduced, the occasional failure to do timely maintenance can be more effective, in fact, maintenance also belongs to the maintenance of a kind, because the quality of the milling equipment is no longer From the cozy operation, the quality is determined by the manufacturer, and the maintenance is in their own hands. If the two combine their effects, they are ideal.