Use of impact crusher in the process of stone production line

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

Use of impact crusher in the process of stone production line

xuanxuan

The Stone Crusher Equipment, the process is supplied to the jaw crusher by the vibrating feeder, and then it is the impact crusher. Here, the jaw crusher plays the role of breaking the bulk material into the impact crusher. To achieve the customer's required particle between 20-60, using the plate hammer on the high-speed rotating rotor, high-speed impact on the material sent into the crushing chamber to break, and the broken material is thrown at high speed in the tangential direction The counter-attack at the other end of the crushing chamber is broken again, and then rebounds from the counter-attack to the hammer, and the above process is repeated.
Whether in the sand production line or stone production line, our aim is to ensure that the impact crusher and the jaw crusher can continue to operate normally. In order to extend the service life of the crusher, we must have a counter crusher in use. It is an indispensable process to carry out periodic maintenance and maintenance. Our factory has done a long time idling for all kinds of crusher equipment before leaving the factory to reduce the occurrence of faults in the future use. When our customers start production of new machines, they must fight the crusher after each shift. Wait for a comprehensive inspection, each component is tightened, the belt drive is normal, the wear of the liner has a comprehensive understanding, periodic and timed inspection.
At the same time of buying the impact crusher capacity, we need to understand which are the wearing parts, because the bulk material will wear the lining and the counter-attack during the crushing process. In the process of replacement, we must follow the principle. First open the rear shelf and then the rear shelf. Remove the coupling bolt of the middle case, then use a wrench to screw it to the hex head of the flip cover, and then slowly open the shelf. At the same time, the rear frame can be hoisted by the hanging device above the rack. Repeat the above process, that is, close the upper shelf. When the counter-attack hammer is worn to a certain extent, it should be adjusted or replaced in time to avoid damage to the fasteners and other components, resulting in greater losses.
The jaw crusher and the impact crusher play an important role in the crushing of the stone production line. Before the problem does not appear, it must be examined in detail. It is not convinced that it will not work properly due to small loss.